How to Tint Car Windows PART-3

Aussie Auto-glass(https://ozautoglass.com.au), one of the best leading auto glass replacement company in Sydney, which is located at 813 princes highway in Tempe.

1.Prep the inside of the window with soapy water and a squeegee. You’re going to go through a lot of soapy water in this process. You can use a hard edge to get in between the seal and the window for a better clean. When done, spray the whole window with soapy water.

2.Peel off the top half of the release liner from the tinting film. Window tint works just like a sticker. There is a removable layer that adheres to the tint and keeps the adhesive solid. You should, however, only peel off only the top half for now– it makes it easier to work with.
•Just gently work the tint between two fingers like you were snapping to get the adhesive layer off.

3.Spray off the now-exposed section with fresh water. You are now ready to adhere the tint to the window.

4.Line up and adhere the top of the tint to the window. The water makes the tint easy to slide around, so you can get the edge of the window perfectly lined up with the top edge of the tint. Your window should still be slightly down.

5.Slightly fold the tint to work it underneath the seal. Once the top edge is on the window, sneak the two sides into the seals to the right and left, using your fingers to get them roughly flush. With one hand, pull back the seal around the window, then use the other hand to push the film under the seal and onto the window.
•Remember to keep everything doused in soapy water to make it easier to move around.

6.Spray down the window again, then use your hard edge to push the water out the edges. Using your squeegee or hard-edge, slowly work the water out by pushing the water to the sides. Push the water out the top and sides, but don’t push towards the bottom, where you have the rest of you liner waiting to be adhered.
•You should keep a hand on the tint at all times to keep it from moving as you squeegee the water out.

7.Aussie Auto-glass(https://ozautoglass.com.au)near you.Roll the window up, then spray the bottom half of the window with soapy water. Don’t skimp on the soapy water — it is essential to prevent the tint from sticking.

8.Pull off the remaining release layer, then spray the exposed tint with water. Make sure both the window and the tint are wet.

9.Use your fingers and hard edge to tuck the bottom of the tint into the bottom seal. Spray off the tint with soapy water again. This is tricky, but should be easy with a hard edge. Pull back the seal with your fingers, then use the hard edge to push the film down and onto the window.

10.Smooth out the window with your hard edge, pushing all the water and air bubbles towards the edges. Work downward and outward whenever possible, spraying the tint with more soapy water to make sure you don’t rip the liner. Keep squeegeeing the water out of the tinting so that it is smooth, as if it was just a part of the window.

Tips
•If your fingerprints are getting on the film, wet the fingers to avoid the mess. Soapy water is your friend.
•Don’t crease the film while applying the tint
•If any of your friends are ready to help, an extra set of hands is always helpful.

Aussie Auto-glass(https://ozautoglass.com.au),With our highly trained team, we are able to provide you with professional windscreen replacement service and satisfied customer service.